214517004
Janome convertible even-feed foot set
Documented forJanome HD-3000 · Janome HD-1000 · Janome HD5000BE · +4
01Troubleshooting guide
A listing described as universal is not enough. A walking or even-feed foot must match the exact machine family, attachment geometry, needle-bar screw and available needle swing, as well as the stitches permitted by the manufacturer.
02
03Step
Write down the full machine model, including any letters or regional suffix, and check its presser-foot or accessory chart.
Match an official accessory reference and confirm shank arrangement, maximum stitch width, bobbin-loading style and any excluded stitches or functions.
Switch off the machine, remove the standard foot and holder only as instructed, then secure the walking foot with its arm or fork in the specified position.
Turn the handwheel through a complete cycle to check clearance, then test at the recommended low or moderate speed on layered scrap using an approved stitch.
04
A compatible foot sits firmly, follows the needle-bar motion without twisting and feeds the upper layer in step with the feed dogs.
Keep to the stitch, width, speed and reverse-sewing limits stated for that exact foot and machine combination.
05Useful parts for this symptom
These products match the subject of this guide. Open the compatibility page to confirm your exact machine, then compare the reference on Amazon.
214517004
Documented forJanome HD-3000 · Janome HD-1000 · Janome HD5000BE · +4
SA140 compatible
Documented forBrother CS6000i · Brother CS7000X · Brother XR9550 · +5
Compatible alternative from another brand